According to the Arapahoe County Public Airport Authority, which operates the airport, the FAA approved a safety mitigation that local FAA representatives proposed during an October 27 Safety Risk Management (SRM) panel. AOPA Vice President of Regulatory Affairs David Boulter participated in the panel. The procedure takes effect today.
Under the mitigation, controllers will instruct aircraft departing the parallel runways (35L/17R and 35R/17L) to turn 10 degrees from their runway centerlines, giving the two departure paths 20 degrees of separation. The airport says the procedure will be phased in gradually, with more traffic allowed in the pattern over time.
The new procedure comes after an FAA order on October 1 to immediately stop simultaneous parallel departures, touch-and-goes, and most pattern work after a safety assessment found aircraft drifting toward one another on departure. The directive came with no warning to the airport, operators, or the air traffic control tower.
"While the initial restrictions were disruptive to the Centennial Airport community, we appreciate the FAA's work with the airport authority, air traffic controllers, flight schools, local pilots, and AOPA to address safety concerns," said AOPA Northwest Mountain Regional Manager Brad Schuster. "Pattern work, including touch-and-goes, is an important part of flight training and helps pilots stay safe and proficient. We hope this plan will allow flight schools and other operations to return to normal as quickly as possible."